Filter
Top Products
STRAIGHT GUIDE FENCE
The optional Straight Guide Fence can be
used to cut various desired widths.
(Fig. 14)
Installing the guide fence: Place the wing
knob through the appropriate hole in the
guide bracket and screw into the housing.
Securely tighten wing knob.
Setting the cutting width: Loosen wing
knob and slide the fence along the guide
bracket to the desired position. Securely
tighten wing knob. Be certain that the flat
washer (supplied) is fitted between the
bottom of the guide fence and wing knob or
the guide fence is likely to slip.
RABBETING DEPTH STOP
The optional rabbeting depth stop accessory
(Fig. 1) allows the user to set any rabbeting
depth from 0 to 5/16 inch. For best results, it
is important that the blade be properly
aligned (See "BLADE ALIGNMENT"). The
width of the rabbet is controlled by the width
fence. The final depth is achieved by
repetitive cutting until the rabbeting depth
guide contacts the workpiece. The maximum
rabbeting depth is 5/16"
Setting the rabbet depth: Loosen wing
knob and using the depth scale on the
rabbeting depth stop, set the desired rabbet
depth. Securely tighten wing knob.
DRIVE BELT
The drive belt is a normal maintenance part
and should be inspected periodically for
wear. If the drive belt shows signs of drying
out, cracking or tearing, it should be
replaced. If the drive belt will not track
properly or comes off the pulleys, it should
be replaced.
Installing new drive belt: Loosen screw and
remove the drive belt cover. Cut and remove
the worn drive belt. Before installing the new
drive belt, clean both pulleys thoroughly.
First place the new drive belt onto the drive
pulley then rotate clockwise while pushing
the belt onto the driven pulley. Reinstall the
drive belt cover and securely tighten screw
(Fig. 15).
-13-
82 mm
max
9 mm
max
FIG. 15
FIG. 14
DRIVE
PULLEY
DRIVEN
PULLEY
OPTIONAL STRAIGHT
GUIDE FENCE
DRIVE
BELT
DRIVE
BELT
COVER
SCREW