Bosch Appliances 00P Home Security System User Manual


  Open as PDF
of 6
 
Bosch Security Systems
10 October 2003
EN
4
LTC9316/00P Instruction Manual Installation
Figure 5 Placement of Pole on Pad
3. Insert the wiring into the 3" diameter hole in the base of the
pole. Be sure all slack is pulled completely through.
4. Insert connecting wiring into the bottom access opening, run
through the pole up to the top access opening. Insert the end
rough the housing connecting hole. Close the top access
opening and make necessary wiring connections at the bottom
access opening (Figure 6).
Access opening plates
Pad
Bolts or
anchor jig
Top access opening
Figure 6 Connecting Wiring Through Pole
5. Slowly lift the pole into the upright position, aligning
the holes of the Base Plate with the Bolts in the concrete
pad (FigurBosch Security Systems10 October 2003e 7).
Figure 7 Lifting the Pole into Position
CAUTION: Pull all slack in the wiring as you lift the pole into
position to keep from pinching and possible damage.
Figure 8 Securing the Pole to the Pad
6. Ensure that the pole is vertical on all sides. Use a
bubble level or plumb bob to check.
7. Secure the pole to the pad with fasteners (Figure 8).
Nut
Lock Washer
Flat Washer
4.3 Mounting the AutoDome
®
1. Align the holes of the AutoDome adapter plate with the
holes on the mounting plate at the top of the pole
(Figure 9).
 previous next