Filter
Top Products
Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
page no.
5
Operating Instructions
This camp stove is designed to operate with a one
pound 7-3/8” high disposable / 14.1 oz. propane gas
tank (DOT 39 Cylinder).
DO NOT ATTEMPT TO REFILL ANY ONE POUND
(14.1 oz.) PROPANE GAS TANKS!
Connecting Gas Tank
1. Make sure the regulator/control valve is in the
“OFF” position. (Figure 1)
2. Lubricate the threads of the regulator valve
with petroleum jelly, insert the gas tank into the
regulator valve and hand-tighten firmly. (Figure 2)
3. Test for leaks
Checking for Leaks
Burner Connection
1. Make sure the control valve is securely fastened to
the burner. (Figure 3)
If your unit was assembled for you, visually check
the connection between the burner and control
valve.
WARNING: Failure to inspect this
connection or follow these instructions
could cause a fire or an explosion which
can cause death, serious bodily injury, or
damage to property.
2. If the burner pipe does not rest flush to the
control valve, please contact 1.800.762.1142 for
assistance.
Regulator / 1lbs. LP Gas Tank Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure control knob is “OFF”. (Figure 1)
3. Spoon several drops of solution, or use squirt bottle,
at the LP gas tank to regulator connection. (Figure
3 & 4)
4. Inspect the solution at the connection, looking for
bubbles.
If NO bubbles appear, the connections are
secure.
If bubbles appear, you have a leak.
a. Loosen and retighten this connection,
making sure the connection is secure.
b. Retest with solution.
If you continue to see bubbles after
several attempts, disconnect propane
source and contact 1.800.762.1142
for assistance.
Lighting
DO NOT expose the camp stove to
flammable vapors or liquids during
lighting.
1. Make sure all labels, packaging and protective films
have been removed from the camp stove.
2. Make sure there are no obstructions of airflow to
the gas unit. Spiders and insects can nest within
and clog the burner / venturi tube at the orifice.
A clogged burner tube can lead to a fire beneath
the appliance.
3. Control knobs must be in the “OFF” position.
4. Wearing Heat reistant gloves, position the lit long
match or lit long butane lighter near the side of the
burner.
a. Turn control knob counterclockwise to “ON”.
b. Remove long match/long butane lighter.
6. If ignition does not occur in 5 seconds, turn burner
control knob “OFF”, wait 5 minutes and repeat
lighting procedure.
6. After lighting, observe the burner flame. Make sure
all burner ports are lit and flame height matches
illustration.
7. Repeat steps 3-6 for second burner.
CAUTION: If burner flame goes out during operation, immediately turn
the gas “OFF” and let the gas clear for about 5 minutes before re-
lighting.
Turning Off
1. Turn control knobs to the “OFF” position.
2. Remove LP gas tank and properly store tank.
First Use
1. Make sure all labels, packaging and protective films have been removed from the camp
stove.
2. Remove manufacturing oils before cooking on this camp stove for the first time, by
operating the camp stove for at least 5 minutes on “ON”. This will “heat clean” the internal
parts and dissipate odors.
Cooking
1. Ignite burner(s) per lighting instructions.
2. Wear protective gloves to place pots and/or pans onto burner grid.
3. Wear protective gloves and use long handled tongs to place food into the pots and/or pans
above the lit burner(s).
4. Adjust controls to desired temperature.
5. Cook until desired internal food temperatures are achieved.
6. Turn camp stove “OFF” by turning control knob to the “OFF” position. Remove LP gas tank
and properly store tank.
Cleaning and Care
CAUTION: All cleaning and maintenance should be done when camp
stove is cool and with the fuel supply disconnected.
CAUTION: DO NOT clean any camp stove part in a self cleaning oven. The
extreme heat will damage the finish.
CAUTION: Keep camp stove clear and free from combusitble materials,
gasolline, and other flammable vapours and liquids.
CAUTION: Do NOT obstruct the flow of combustion and ventilation air.
Notices
1. Abrasive cleaners will damage this product.
2. Never use oven cleaner to clean any part of camp stove.
3. Do not clean any camp stove part in a self cleaning oven. The extreme heat will
damage the finish.
Inspecting
This camp stove should be inspected on a regular basis to ensure product safety and longer
product life.
WARNING: Do NOT attempt to clean this camp stove unless the flames are
COMPLETELY out and unit is cool to the touch.
1. Check burner to make sure it is secure.
2. Check venturi to make sure it is clear and free of spider nests.
3. Check all gas connections for leaks.
4. Check components for any signs of damage or rust.
5. If damage to any component is detected, do NOT operate until repairs are executed.
Cleaning Surfaces
WARNING: Do NOT attempt to clean this camp stove unless the flames are
COMPLETELY out and unit is cool to the touch.
WARNING: Do NOT use oven cleaner or abrasive cleaners as they will damage this
product.
1. Wipe surfaces clean with mild dishwashing detergent or baking soda.
2. For stubborn surfaces use a citrus based degreaser and a nylon scrubbing brush.
3. Rinse clean with water.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Match
Figure 6
1/2"
12.7 mm
6.4mm
0mm
1/4"
0"
Flame