Filter
Top Products
2
FORLI' Italy
1.0 IDENTIFICATION
The identification plate of the machine is affixed
outside the plate casing (see fig. 1).
1.1 MANUFACTURER
WTA srl
Via Virgilio, 3
47100 FORLI' - ITALY
P. IVA 00718330400
1.2 DEFINITIONS
In this handbook, three types of “safety graphics” are
used to point out different levels of danger or any other
important information:
DANGER
Draws the attention to potentially dangerous situations
which may cause serious personal injury.
CAUTION
Draws the attention to potentially dangerous situations
which may cause personal injury or material damage.
IMPORTANT
Draws the attention to situations which may cause
malfunctioning or damage to the machine.
1.3 TRANSPORT - HANDLING - STORAGE
1.3.1 STORAGE CONDITIONS
The air conditioner is protected against sudden impact by
suitable packing consisting of cardboard, polystyrene and
a wooden frame support.
The air conditioner should be stored horizontally in a dry
and well-ventilated room.
1.3.2 WEIGHT
Gross weight (including packing):
Mod. 1000 .......................................... Kg 26
Mod. 1300 .......................................... Kg 28
1.3.3 OVERALL DIMENSIONS
See fig. 2:
Model
1000-1300
A ................................. mm 940
B ................................. mm 695
C ................................. mm 225
D ................................. mm 300
E .................................. mm 640
F .................................. mm 340
1.3.4 HANDLING
The packed air conditioner can be handled by normal
means of lifting and transport.
Boxes are fitted with spacers which enable the use of
manual fork-lifts.
DANGER
Strictly observe the accident prevention precautions
and safety regulations during lifting and transport,
and always use machines
with a higher maximum capacity
than the load to be lifted.
2.0 INSTALLATION
2.1 AUTHORISED PERSONNEL
The air conditioner shall be installed onto the vehicle -i.e.
camping-cars, caravans, motorhomes, only and
exclusively by skilled technicians or workshops, authorized
by W.T.A.
According to the vehicle dimensions and to the real air
conditioning needs one or more units can be installed.
If the installation is carried out by non-authorized
technicians or workshops, W.T.A. disclaims any
responsibility for the unit safety and efficient running
according to the M.D. 89/392/EC.
DANGER
The instructions given in sections 2.2 are addressed
to qualified technicians only.
2.2 MOUNTING THE AIR CONDITIONER
BLIZZARD air conditioners can be installed on openings
with following sizes: 35x35 cm. up to 40x40 cm max. It is
possible to use an existing air inlet or drill a new one. In
such case, make sure that the roof can tolerate the air
conditioner weight and, in case, stiffen it suitably.
Remove the skylight cover (fig. 3).
Carefully clean the surfaces around the installation
opening, remove any waste, and fill any surrounding hole