Filter
Top Products
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
WARNING: Do not use on any unsealed hard floor surfaces. Additionally, on
surfaces that have been treated with wax or some no wax floors, the sheen may be
removed by the heat and steam action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding. We also recommend that you
check the use and care instructions from the floor manufacturer.
HINTS FOR OPTIMUM USE
General
NOTICE:
Never use the steam mop without first attaching a cleaning pad.
• Always vacuum or sweep the floor before using the steam mop.
• The easiest way to use the machine is to tilt the handle to a 45˚ angle and clean slowly,
covering a small area at a time.
• Do not use chemical cleaners with your steam mop. To remove stubborn stains from
vinyl or linoleum floors, you can pre-treat with a mild detergent and some water before
using the steam mop.
Steam cleaning
• Place a cleaning pad (6) on the floor with the ʻhook & loopʼ side facing up.
• Raise the steam mop off the resting mat (7) and lightly press it down onto the cleaning
pad (6).
• Place the steam mop on the resting mat.
• Plug the steam mop into the outlet.
• Turn the SmartSelect
TM
dial (2) to the required setting.
• Press the ON/OFF button (1). It takes approximately 15 seconds for the steam mop to
heat up.
• Pulling the handle (4) back will activate the steam pump.
• It take a few seconds for steam to enter the cleaning pad. The steam mop will now glide
easily over the surface to be sanitized/cleaned. NOTE: When using for the first time, the
appliance may take longer than the normal 15 second startup time to steam. This will
only occur during the first use.
• Push and pull the steam mop slowly across the floor to thoroughly steam clean each
section.
NOTE: During use you may turn off the steam pump by returning the handle to the
upright position, this convenient feature will allow you to place the steam mop on the
resting mat so that you may move items of furniture without the need to switch the
appliance off.
• When you have finished using the steam mop, return the handle (4) to the upright
position and turn it ʻOFFʼ, place it on the resting mat (7) and wait until the steam mop
cools down. (approximately five minutes)
NOTICE: It is important to monitor the water level in the water tank. To refill the water
tank and continue to sanitize/clean, return the handle (4) to the upright position and turn
the steam mop ʻOFFʼ. Unplug the unit from the wall outlet and refill the water tank (3)
using the water cup (8) supplied.
NOTICE: Never leave the steam mop in one spot on any surface for any period of time.
Always place the steam mop on the resting mat (7) with the handle (4) in the upright
position when stationary and make sure the steam mop is turned off when not in use.
7