Filter
Top Products
11
ENGLISH
(Original instructions)
u After picking up liquid substances clean the appliance and lter immediately. Mold
and mildew may form if the unit is not properly cleaned after wet pickups.
u Before charging, be sure to empty all liquid contents and dry thoroughly, to avoid
damage to your appliance.
Optimising the suction force
In order to keep the suction force optimised, the lters must be cleared regularly during
use.
Emptying and cleaning the product.
Removing the dust bowl and lters (g. F & G).
Warning! The lters are re-usable and should be cleaned regularly.
u Press the bowl release button (2) and pull the dust bowl (3) straight off.
u While holding the dust bowl over a bin or sink, pull out the lter to empty the con-
tents of the bowl.
u To replace the dust bowl, place it back onto the handle until it “clicks” rmly into
position.
Warning! Never use the appliance without the lters. Optimum dust collection will only
be achieved with clean lters.
Foam insert (g. H) (NW3620N & NW4820N Only)
u Place the foam insert (8) into the centre of the wet/dry deector (9).
Warning! Never use the appliance for wet applications without the water deector and
foam insert tted.
Pre-lter (g. I) (NV2410N, NV2420N, NV3610N, NV3620N, NV4820N &
NV4820CN Olny)
The Filter and pre-lter can be separated to allow better cleaning.
u Twist the pre-lter (7) in an anti-clockwise direction and lift from the lter (6).
Cleaning the dust bowls and lters
u The dust bowls and lters can be washed in warm soapy water.
u Make sure that the lters and the dust bowl are dry before re-tting.
Replacing the lters
The lters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement lters are available from your Black & Decker dealer:
For models: NV2410N, NV2420N, NV3610N, NV3620N, NV4820N & NV4820CN use
lter part number FLVD10-XJ
For models: NW3620N & NW4820N use lter part number FLWD10-XJ
Maintenance
Your Black & Decker corded/cordless appliance/tool has been designed to operate over
a long period of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/ cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/tool if the appliance/tool
has a separate battery pack.
u Or run the battery down completely if it is integral and then switch off.
u Unplug the charger before cleaning it. Your charger does not require any mainte-
nance apart from regular cleaning.