NOTE: The cleaner the filter is, the better the product will perform.
•The dust bowl can also be washed in warm soapy
water as shown in figure G. Ensure that it is dry before
re-attaching.
• Never immerse the product in water. A damp cloth and
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely dry
before re-use or storing.
RUN TIME
•Whenfullycharged,theaverageeffectiveusagetimesarebetween10-15minutes.
•Itmaytakeseveralchargingsbeforethesetimescanbeachieved.
OTHER INFORMATION
If the product does not work, check the following:
•Thechargerwascorrectlypluggedinforrecharge.(Itfeelsslightlywarmtothetouch.)
•Thechargercordisnotdamagedandiscorrectlyattachedtothebase.
•Thechargerispluggedintoaworkingelectricaloutlet.
ACCESSORIES
The performance of your apliance depends on the accessory used. Black & Decker
accessories are engineered to high quality standards and are designed to enhance the
performance of your apliance.
•FilteraccessorynumberVF200SP.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the
vac; never immerse any part of the vac into a liquid.
NOTE: Make sure the vacuum is completely dry before using it.
IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment(otherthanthoselistedinthismanual)shouldbeperformedbyauthorizedservice
centersorotherqualifiedserviceorganizations,alwaysusingidenticalreplacementparts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent lithium-ion batteries in
the trash or municipal solid waste stream and the RBRC program provides an
7
TROUBLESHOOTING
Problem Possible Cause Possible Solution
•Unitwillnotstart. •Batterynotinstalledproperly. •Checkbatteryinstallation.
•Batterynotcharged. •Checkbatterycharging
requirements.
•Batterywillnotcharge. •Batterynotinsertedintocharger. •Insertbatteryintocharger
until red LED appears.
•Chargernotpluggedin. •Plugchargerintoaworking
outlet. Refer to “Important
Charging Notes” for more
details.
•Checkcurrentatreceptacle
by plugging in a lamp or other
appliance.
•Checktoseeifreceptacleis
connected to a light switch
which turns power off when
you turn out the lights.
•Surroundingairtemperature •Movechargerandtooltoa
too hot or too cold. surrounding air temperature
of above 40 degree F(4,5°C)
or below 105 degree F
(+40,5°C).
For assistance with your product, visit our website www.blackanddecker.com for the location of
the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
G