Filter
Top Products
•
Leaks from battery cells can occur under extreme conditions. If the liquid, which is a
20-35% solution of potassium hydroxide, gets on the skin (1) wash quickly with soap and
water or (2) neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into
the eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek
medical attention.
• The charger supplied with this product is intended to be plugged in such that it is correctly
orientated in a vertical or floor mount position.
WARNING: Do not look into the air vents when the unit is switched on, as sometimes
there is a possibility of small debris being discharged from the air vents, especially after
cleaning / replacement of the filters as debris inside the unit can be disturbed.
INSTALLATION INSTRUCTIONS (FIG. B)
The charging bracket can be mounted to most walls or left unattached on a flat surface. Fix
the wall mount within reach of an electrical outlet. Mount securely into framing studs or
wallboard using the hardware provided. Next plug power supply plug into nearby electrical
outlet. Ensure cord is not too tight so as to pull unit off wall mount.
WARNING: Do not mount the charging bracket directly over the electrical outlet. Excess
water from the bowl could drip onto the outlet and create a hazard.
RECHARGING (FIG. C)
From new, the rechargable cells of the product need a minimum charge time of 16 hours to
ensure full power. We suggest you fully discharge the product when it is used for the first
time as this will help the cells recharge faster.
The switch must be in the off (“O”) position, the product will not charge if it is in any other
position.
Make sure that the product is fully mounted on the charging bracket. There is an
arrow on the charging base that must line up with the split of the dust bowl and the
handle. While charging, the product may get warm, this is perfectly normal and safe. It can
remain on charge indefinitely without damage or danger. It is not possible to “overcharge”
the battery cells with the charger provided.
For a better battery life, it is recommended to fully run the battery down and recharge it at
least once a month.
O
PERATION (FIG. D)
T
o start, slide the On/Off switch forward (i.e. “O”= Off, “I” = On). To stop, slide the switch
b
ack.
For best performance on hard surface wet pickups, insert Squeegee into the Bowl Nozzle
Opening.
Do not fill the bowl beyond the end of the intake chute. If there is any liquid in the bowl, do
not turn the unit upside down, sideways, point the nozzle upward, or shake the vac
excessively.
After picking up liquid substances clean the vac and filter immediately. Mold and mildew
may form if the unit is not properly cleaned after wet pickups.
Always return the product to the power supply immediately after use so that it will be ready
and fully charged for the next use. Ensure that the product is fully engaged with the power
supply plug.
CLEANING THE PRODUCT (FIGS . E-I)
WARNING: Never use the Dustbuster without its filters.
NOTE: The filters are re-usable, do not confuse them with disposable dust bags, and do not
throw them away when the product is emptied. We recommend that you replace the filters
every 6-9 months depending on frequency of use.
FIG. E
Remove the dust bowl by turning it counterclockwise slightly and pulling it away
from the handle. To replace the bowl, place it back onto the handle and twist it clockwise
until it “clicks” firmly into position.
FIG. F Empty the dust from the bowl and wash if necessary (see Fig. H).
FIG. G While holding the bowl over a wastebasket, pull out the foam filter and hard filter
to empty the contents of the bowl.
FIG. H Wash the filter regularly using warm, soapy water and ensure that it is completely
dry before using it again. The cleaner the filters are, the better the product will perform. It is
very important that the filter is correctly in position before use. The dust bowl can also be
washed in warm soapy water. Ensure that it is dry before re-attaching.
IMPORTANT: Maximum dust collection will only be obtained with clean filters and an empty
dust bowl. If dust begins to fall back out of the product after it is switched off, this indicates
that the bowl is full and requires emptying.
FIG. I Never immerse the product in water. A damp cloth and soapy water should be
used to clean the exterior of the motor section. Always ensure the product is completely
dry before re-use or storing.
ECONOMIC USAGE
• Your product is very economical to charge. While it is charging it uses less than half the
amount of electricity used by a light bulb.
• When fully charged, the average effective usage times are between 8-10 minutes.
• It may take several chargings before these times can be achieved.
OTHER INFORMATION
If the product does not work, check the following:
• The power supply plug was correctly plugged in for recharge. ( It feels slightly warm to the
touch.)
• The power supply plug is not damaged and is correctly attached to the base.
• The power supply plug is plugged into a working electrical outlet.
ACCESSORIES
Accessories are fitted into the nose of the product as shown in figure J.
BATTERY REMOVAL AND DISPOSAL
NOTE: Once removed, the battery cannot be refitted.
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries. When the
batteries no longer hold a charge, they should be removed from the Vac and recycled. They
must be properly disposed of and not incinerated.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or Authorized
Service Center.
To remove the battery pack for disposal: (Fig. K)
WARNING: Disconnect the appliance from the power supply before removing the bat-
tery.
Discharge the battery by operating the appliance until the motor stops.
Remove the screws from the appliance housing.
Open the appliance and remove the battery, the attached motor and switch module. Use a
screwdriver to detach the battery from the motor and switch module – do not switch on.
Place the battery in suitable packaging to ensure that the terminals cannot be short-
circuited.
If the batteries have leaked or vented, protective gloves should be worn before touching the
casing.
IMPORTANT: DO NOT remove the batteries from inside the plastic casing. Do not replace
with any batteries other than those supplied by Black & Decker.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
NOTE: Make sure the vacuum is completely dry before using it.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service organizations, always using identical replacement parts.
Troubleshooting
P
roblem
P
ossible Cause
P
ossible Solution
• Unit will not start. • Battery not charged. • Check battery charging requirements.
• Battery will not charge. • Charger not plugged in. • Plug charger into a working outlet.
Refer to “Important Charging Notes” for
more details.
• Check current at receptacle by
plugging in a lamp or other appliance.
• Check to see if receptacle is
connected to a light switch which turns
power off when you turn out the lights.
• Surrounding air • Move charger and tool to a
temperature too hot or surrounding air temperature of
too cold. above 40 degree F(4,5°C)
or below 105 degree F (+40,5°C).
SERVICE
Black & Decker offers a full network of company-owned and authorized service
locations. All Black & Decker Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you.
Technical Data
Solamente para propósito de Argentina:
Importado por: Black & Decker Argentina S.A.
Marcos Sastre 1998
Ricardo Rojas, Partido de Tigre
Buenos Aires, Argentina
CP: B1610CRJ
Tel.: (11) 4726-4400
Solamente para propósito de México:
Importado por: Black & Decker S.A. de C.V.
Bosques de Cidros, Acceso Radiatas No. 42
3a. Sección de Bosques de las Lomas
Delegación Cuajimalpa,
05120, México D.F.
Tel. (52) 555-326-7100
Solamente para propósitos de CCA
Importado por: Black & Decker LLC
Calle Miguel Brostella Final
Edificio Milano I, Mezanine 5,6 y 7
El Dorado, Panama
Tel. 507-360.5700
Solamente para propósito de Chile:
Importado por: Black & Decker de Chile, S.A.
Av. Pdte. Eduardo Frei M. 6001-67 Conchalí
Santiago de Chile
Tel. (56-2) 687 1700
Solamente para propósitos de Colombia
Importado por: Black & Decker de Colombia, S.A.
Carrera 85D # 51-65, Bodega 23
Complejo Logístico San Cayetano
Bogota - Colombia
Tel. 744-7100
Black & Decker del Perú S.A.
Av. Enrique Meiggs 227.
Pque. Industrial - Callao
Teléfono: (511) 614-4242
RUC 20266596805
Impreso en China
Printed in China
90529151
08/24/07
Charger
V
oltage AR
Voltage B2C
Voltage B3
Model No.
A
A090020D
VA090020D
UA090020
Input
2
20V ~ 50 Hz 45mA
220V ~ 50 Hz 45mA
120V ~ 60 Hz 5W
Output
9
V ~ 200mA
9V ~ 200mA
9V ~ 200mA
CHV7202
Voltage V 7.2V
B
attery type NiCd
Weight kg 0.95