Filter
Top Products
Connecting the hose (fig. C)
• Insert the hose connector (15) into the inlet (16) of the appliance.
• Slide the hose further until the release buttons (16) click into place.
• To disconnect the hose, press the release buttons and pull out the hose.
Mounting the extension tube (fig. D)
• Press the lock button (17) and slide the hose nozzle (18) into the tube (8) until it clicks into
place.
• To remove the tube, press the lock button and pull the hose out of the tube.
Mounting the suction head (fig. E)
The suction head (9) allows for vacuuming on carpet and hard surfaces (e.g. laminate and
tiles).
• Press the lock button (19) and slide the tube (8) into the suction head (9) until it clicks into
place.
• To remove the suction head, press the lock button and pull the tube out of the suction head.
Mounting the wooden floor brush (fig. E)
The wooden floor brush (13) allows for vacuuming on wooden and polished surfaces.
• Press the lock button (19) and slide the tube (8) into the wooden floor brush until it clicks
into place.
• To remove the wooden floor brush, press the lock button and pull the tube out of the
wooden floor brush.
Mounting the turbo brush (fig. E)
The turbo brush (15) allows for deep carpet cleaning.
• Press the lock button (19) and slide the tube (8) into the turbo brush until it clicks into place.
• To remove the turbo brush, press the lock button and pull the tube out of the turbo brush.
Mounting accessories (fig. E & F)
The crevice tool (11) allows for vacuuming in narrow and hard-to-reach places. The brush
tool (12) allows for vacuuming on furniture, blinds, curtains, windows and stairs. The
accessories can be mounted on both the hose (6) and the tube (8). When not in use, the
accessories can be stored in the accessory holder (20).
• Remove the accessory from the holder (fig. E).
• Press the lock button (17 or 19) and slide the accessory onto the hose nozzle (18) or the
tube (8) (fig. F).
• To remove an accessory, press the lock button (17 or 19) and pull the accessory off.
Unwinding and rewinding the cord (fig. A)
The cord rewind button (3) can be operated by hand or foot.
• Before use, pull a sufficient length of cord from the back of the appliance.
• After use, press the cord rewind button to store the cord back into place. Manually guide the
cord to ensure it does not swing back. Ensure the plug is correctly located.
Adjusting the length of the tube (fig. G)
The extension tube (8) can be adjusted in 21 steps.
• Engage the adjustment knob (21) and slide the tube to the desired length.
• Release the knob.
Adjusting the suction head (fig. E)
• For vacuuming on carpets, switch the floor surface selector (22) into the up position.
• For vacuuming on laminates, tiles, etc., switch the floor surface selector into the down
position.
Switching on and off (fig. A)
The on/off switch (1) can be operated by hand or foot.
• To switch the appliance on, press the on/off switch (1).
• To switch the appliance off, press the on/off switch again.
Assembly
17
15
16
17
C
D
18
19
8
E
12
11
6
9 23
13
20
8
18
19
15
8
12
14
21
11
F
8
22
G
H
I
24
35
Q
2625
J
28
29
27
K
L
30527
M
31 14
N
O
33
34
P
Use