Bissell 8910 Carpet Cleaner User Manual


 
5
How To Put It Together
How to use this guide
This User’s Guide has been designed to help you get the utmost
satisfaction from your BISSELL ProHeat. You’ll find assembly and
operating instructions, safety precautions, as well as maintenance
and troubleshooting instructions. Please read this Guide thoroughly
before assembling your deep cleaner.
Pay particular attention to the product diagram, assembly
instructions, and part names. Locate and organize all parts before
assembly. Familiarize yourself with the parts and where they
go. Following this User’s Guide will greatly enhance your ability
to get the most performance from your BISSELL ProHeat for
many years.
Your ProHeat comes in 3,
easy to assemble components.
The only tool you will need to assemble your cleaner is a Phillips
head screwdriver.
Upper Handle
Lower Handle
Tool Caddy
Refer to Assembly Diagram on page 4
Slide upper handle onto lower handle.
Feed bundled power cord through Tool Caddy from caddy’s
flat side.
Align upper handle holes and Tool Caddy holes.
Place hex nut into back of Tool Caddy and hold in place. Insert
bolt from front to back turning into the hex nut until snug. Do
not over tighten. Repeat for the second bolt and hex nut.
Insert 2 screws into lower 2 holes.
Turn until snug.
Snap tools into Storage on the Tool Caddy as shown in
figure 6.
Wrap Power Cord and Flex Hose as shown in figure 7.
ProHeat assembly is now complete.
WARNING:
Do Not plug in your cleaner
until you have completely
assembled it per the following
instructions and are familiar
with all instructions and
operating procedures.
1.
2.
3.
4.
5.
6.
7.
O
N
O
FF
ON
O
F
F
6
7
5
4
2