Bissell 8910 Carpet Cleaner User Manual


 
21
DirtLifter PowerBrush does not turn.
Possible Causes Remedies
The Brush Belt or Pump Belt Turn the machine OFF and unplug from
is off or broken. the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into
the lower slot of the Belt Access door
to release the lower snap. If necessary,
insert the blade end into the upper slot
to release the upper snap. Examine the
belt for breakage. If broken refer to
pages 18-19.
Carpet Protector is not spraying.
Possible Causes Remedies
Bottle not connected Follow instructions on cartridge
properly to the tool. assuring proper fit.
Solution clogging the Soak applicator tool only in hot water.
Spray trigger. Spray without the cartridge attached to
purge any residual Solution left in
the tool.
Applicator tool spray is blocked. Soak applicator tool only in hot water.
Spray without the cartridge attached to
purge any residual Solution left in
the tool.
SmartMix not set on water/rinse Set to proper setting.
carpet protector setting.
ReadyTool dial not set on tool setting. Set to tool setting.
Cleaner not picking up solution.
Possible Causes Remedies
Ready Tools dial may be at the Set ReadyTools dial to either Tools or
wrong setting for the cleaning job. PreTreat or Floor Cleaning.
Nozzle Window may not be Press down firmly on the black oval
properly attached. gasket at the top window to make sure
the two tabs on the back of the Nozzle
Window are snapped into the mating
slots in the main housing.
Tank-in-Tank lid is not Re-install lid; refer to The Operations
properly installed. section.
Tank-in-Tank is not properly seated. Tank-In-Tank must be firmly seated to
function; remove and reseat Tank-in-Tank.
Poor tool position. Adjust angle; apply more downward
(Hand held attachments only). pressure.
Tank-in-Tank has picked up Empty Tank-in-Tank, refer to
maximum dirty water. the Operations section.
Troubleshooting Continued