Bissell 88D6 Vacuum Cleaner User Manual


 
Manual/hose cleaning
1. Remove the hose from the unit by
depressing the release button.
2. Remove the Tough Stain Brush from the
back of the unit by depressing the release
button. Attach the Tough Stain Brush onto
the grip of the flex hose.
3. Select the manual/hose button on the
control panel to start the SpotBot.
NOTE: In manual mode, the SpotBot will not
turn on until the hose is removed from the
unit. If it is not removed within 30 seconds of
pushing the start button, the unit will shut off.
4. If your unit has a built in heater (not
standard on all models) press the heater
button to turn on the heat feature. Begin
cleaning by holding the tool no more than six
inches above the soiled surface. Depress the
spray trigger for about five seconds to apply
the cleaning solution to the soiled area then
release the spray trigger. Be careful not to
over wet.
5. Using the brush on the tool, gently scrub the
soiled area for about 30 seconds or until the
soiled area appears to be clean.
6. To suction up the dirt and cleaning solution,
position the suction nozzle over the cleaned
area, apply downward pressure on the tool,
and pull nozzle toward you. You should see the
dirty water pass through the nozzle. Continue
until no more water can be removed. Normally,
this step will require no more than one minute
of back and forth passes.
NOTE: In manual mode, the SpotBot is
equipped with a safety feature which will
shut the unit off after 30 minutes. Press
start to resume cleaning.
7. If the stain is still visible, repeat steps 4-6
as necessary.
8. When the cleaning is complete, lightly drag
the suction nozzle across the stain for about
two minutes to further aid in drying the
cleaned area.
9. Press the manual/hose button to turn off
the SpotBot.
10
w ww.b is se ll .c om
Operation
Tip:
Check upholstery stuffing
before cleaning. Colored
stuffing may bleed through
the fabric when it becomes
wet.
Tip:
One of the effective stain
removing ingredients in Oxy
GEN2 is Hydrogen Peroxide.
Certain people may be
affected by the formula
when it comes into contact
with their skin; it may turn
the skin white and/or cause
tingling. Washing your hands
after use and applying hand
lotion will remove any
possible white discoloration.
1
2a
2b