Filter
Top Products
w w w . b i s s e l l . c o m
17
Troubleshooting
DirtLifter PowerBrush does not turn
Possible cause Remedies
1. The brush belt or pump belt is off or broken. 1. Refer to Remedy 4 on page 16 to check if brush belt or
pump belt is broken.
Cleaner not picking up solution
Possible cause Remedies
1. ReadyTools dial may be on the wrong setting 1. Set ReadyTools dial to either FLOOR CLEANING or TOOLS.
for the cleaning job.
2. Poor tool position. (Hand held attachments only). 2. Adjust angle; apply more downward pressure.
3. Removable nozzle may not be properly attached. 3. Make sure nozzle is on correctly by slightly raising front
of machine to line up slots on the base of the machine
with the hooks on nozzle. Attach at base first and
then click nozzle into place. Refer to image 5 on page 12.
4. 2-in-1 water tank lid is not properly installed. 4. Re-install lid; refer to the images on page 10.
5. 2-in-1 water tank is not properly seated. 5. 2-in-1 water tank must be firmly seated to function; remove
and reseat 2-in-1 water tank.
6. 2-in-1 water tank has picked up maximum dirty water. 6. Empty 2-in-1 water tank and refill, refer to the Operation
section.
7. The lint screen may be clogged. 7. Clean out lint screen. Refer to page 12.
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.