Filter
Top Products
w w w . b i s s e l l . c o m
11
Operations
Carpet cleaning
1. Plug the deep cleaner into a proper
outlet. Set ReadyTools dial to the FLOOR
CLEANING setting. Turn the power on
by pressing the red power switch on
the back of the unit with your foot. Turn
heater switch (located on side of unit)
to the on position. Allow one minute for
the built-in heater to warm up before
cleaning.
NOTE: The Heathly Home Fresh
Clean will be fully warmed and
will provide optimal performance
after one minute of continuous
heated cleaning.
2. With your foot, press the gray handle
release lever located on the back of unit
below water tank to detent handle.
3. While pressing the spray trigger, make
one slow forward wet pass and another
back. Let the built-in heater, BISSELL 2X
advanced deep cleaning formula and
DirtLifter PowerBrush do the work for
you. Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over
the same area to remove any residual
dirty water and aid in drying.
5. Repeat cleaning passes until solution
being suctioned up appears clean.
Continue passes without pressing the
spray trigger until you can’t see any
more water being suctioned up.
Tip:
Thorough vacuuming before deep
cleaning will prevent early clogging
of the lint trap.
Handle Release Power Switch
Heater Switch