Filter
Top Products
12
www.bissell.com 800.237.7691
WARNING:
To reduce the risk of fire, electric
shock or injury, unplug from the
outlet before servicing.
Troubleshooting
Reduced Spray OR No Spray
Possible cause Remedies
1. Clean/solution tank may be empty 1. Turn power switch OFF; Refill tank with
clean hot tap water and formula
2. Clean/solution tank may not be seated properly 2. Turn power switch OFF; remove tank
and reseat
3. Pump may have lost prime 3. Turn power switch OFF ( O ); after 1 minute
turn ON ( I ) and depress spray trigger
Be sure there is cleaning formula in the
clean/solution tank, it will make the
machine prime faster
No spray through the hose
Possible cause Remedies
1. Pump may not be primed 1. Turn ReadyTools dial to FLOOR CLEANING
and depress trigger for a few a seconds
until you see suction coming up the nozzle
Turn ReadyTools dial back to TOOLS
TLR PowerRoller Does Not Turn
Possible cause Remedies
1. The brush belt is off or broken 1. Refer to page 11, steps 1-5 for instructions
on how to access the belt
2. Look at the belt and check for breakage
or mis-alignment on the cogs. IF there is
no evidence, replace all parts following
steps 8-11.
3. In the event your belt is broken, a
replacement belt may be ordered at
www.bissell.com or by calling BISSELL
consumer services at 800-237-7691.
Refer to the parts list on page 14. Complete
installation instructions will come with
the replacement belt
Machine not picking up solution
Possible cause Remedies
1. Collection tank may not be seated properly 1. Turn power switch OFF; reseat tank
2. ReadyTools dial may be on TOOLS 2. Turn ReadyTools dial to FLOOR CLEANING
3. Float may have shut off 3. Turn power switch OFF and empty tank if
necessary. If tank is not full, wait
30 seconds and turn power switch ON
4. Collection tank may be full 4. Turn power switch OFF and empty tank
ug120-4080_7350_908.indd 12 10/14/08 1:26:02 PM