Filter
Top Products
14
Operation
Cleaning with attachments (continued)
2. Follow the instructions on pages 10 & 11 for filling the
2-in-1 water tank and the formula tank.
3. Set ReadyTools dial to the hose attachments setting.
This will allow spray and suction from the hose.
4. Set custom clean dial for heavy traffic, normal
clean, light clean, or water rinse as desired.
5. Attach the cleaning tool to the end of the hose.
6. Plug in and turn on the power switch and heater (if desired).
7. Clean by pressing the trigger to spray solution onto
the area to be cleaned. Slowly move the tool back
and forth over the soiled surface. Release the trigger
to suction soiled water. Continue to clean in the area,
working in small sections, until no more dirt can be
removed. Rinse (optional) and suction as needed.
Caution: Do no overwet.
8. Remove and rinse tools in clean, running water.
Dry and replace in the tool caddy.
9. It is recommended that you suction clean water
from a bowl to rinse out the hose.
10. Before replacing lift end of hose and stretch out to
ensure all water is cleared from hose.
11. Coil flex hose around the tool caddy.
12. Empty 2-in-1 water tank and rinse out,
following the instructions on page 12.
13. Return ReadyTools dial to floor setting.
5.
9.
10.
WARNING:
To reduce the risk of
injury, be extra careful
when cleaning stairs.
Make sure machine is
secure and level.
w ww.b is se ll .c a 1 -8 00 -2 63 -2 53 5