Filter
Top Products
18
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Maintenance and care
Machine care (continued)
5. The inside of the end caps by the brush rolls
can be wiped out with a clean paper towel,
or, if a more thorough cleaning is desired, the
end caps can be taken off using a Phillips
head screwdriver and rinsed clean.
Replace after cleaning.
6. Any loose hair or debris can be pulled from the
brush rolls and thrown away. For the most
thorough clean before storage, follow directions
on pages 17 & 18 for removal and replacement
of the brush rolls and belts.
7. To clean attachments that may have been
used, remove from hose and rinse in clean,
running water. Dry and replace attach-
ment in the tool caddy. Clean the hose by
suctioning clean water from the tap. Before
replacing, lift end of hose and stretch out to
ensure all water is cleared from hose. Refer
to page 13, illustrations 9 & 10.
8. After carpet is dry, vacuum again to remove
hair and fuzz.
Small belt removal and replacement
Occasional replacement of one or both belts
may become necessary. If that is needed, please
follow the instructions below.
1. Turn off the machine, and unplug it from
the outlet.
2. Remove both the 2-in-1 water tank and the
formula tank. Set aside.
3. Unscrew the front nozzle and remove it.
Set aside.
4. Turn the machine on its side.
IMPORTANT: cord side down.
5. Remove the clear end cap by unscrewing
the 2 black screws. Take care not to drop
the screws into the unit.
6. Remove 1 silver screw.
7. Remove pivot arm by gently lifting up.
8. Remove small brush belt.
9. Replace small brush belt, and reverse
steps above.
2
1
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
1. 2.
3.
4. 5.
6. 7.
8. 9.