Filter
Top Products
Hard floor cleaning (continued)
11. Allow adequate time for floors to dry.
12. Remove hard floor tool, rinse and dry before storing.
13. If any formula remains in the formula tank,
pour it back into the Hard Floor Solutions
bottle for use the next time.
14
. Rinse out the formula tank.
Machine storage
Once your cleaning is complete, make sure
the 2-in-1 water tank is emptied, rinsed out,
and dried before the next use. The formula
tank can remain filled and ready to go, or it
can simply be emptied back into the formula
bottle if that is more convenient.
Note: Store cleaner in a protected, dry area.
Since this product uses water, it must not be
stored where there is a danger of freezing.
Freezing will damage internal components
and void the warranty.
Machine care
For best results, a few simple steps can assure
your machine is well maintained after your
cleaning is complete.
1. Turn power and heater switches OFF (O).
Unplug the machine and wrap the power cord.
2. After emptying the 2-in-1 water tank, rinse
it out at a faucet with running hot tap water,
taking care to clean underneath the heavy
duty bladder, and all around it.
3. The top half of the tank can be rinsed clean
through the nozzle area. Also, pop out the red
filter underneath the top half of the tank and
rinse that out. Replace before putting the top
and bottom halves of the tank together.
4. Before you place the cleaned 2-in-1 water tank
back onto the machine, simply unscrew the floor
nozzle using a Phillips head screwdriver. This
can be rinsed out at the faucet. Then replace
back onto the machine by starting from the
bottom of the nozzle and hooking the tabs into
the holes on the bottom sides of the machine.
Secure into place with the screw.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
Maintenance and care
17
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Filter
Tip:
Let all parts dry completely
before storing
3.
Operation