Bissell 6594 Vacuum Cleaner User Manual


 
Use only BISSELL Style 10 Replacement Filters in your BISSELL
PowerForce Bagless.
Unplug the cleaner from electrical outlet.
Remove the Dirt Container as described in the previous section. Grasp
the Filter Cup located at the bottom of the Dirt Container and twist
counterclockwise to unlock and remove.
Grasp the Circular Filters and twist to unlock. Pull straight
up to remove.
Separate the Outer foam and Inner pleated Circular Filters. Wash each
individually by hand in warm water. Mild detergent may be used if
desired. Rinse well, then air dry thoroughly before putting them back
together and replacing in Filter Cup.
The Filter Cup may be washed in warm water with a mild detergent.
Make sure it is completely dry before reassembling with filters.
The Upper Tank and Louvers may also be wiped clean with a damp
cloth. Reach underneath the Upper Tank and turn the rim of the Louvers
to unlock. Pull straight down to remove.
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from debris. It is located
underneath the Dirt Container and Filter Cup in the center of the
round part of the Lock ‘n Seal Lever.
Remove the small round Filter and any debris on top of it. Rinse well
under warm water, then air dry thoroughly before replacing.
Use only BISSELL Style 10 Replacement Filters in your
BISSELL PowerForce Bagless.
Unplug the cleaner from electrical outlet.
The Post-Motor Filter assists in the filtration process to return clean
air to the room. It is located behind the door on the front of the
cleaner. When the filter becomes dirty, open the door, remove the
filter and clean.
The Post-Motor Filter may be hand washed in warm water. Mild
detergent may be used if desired. Rinse well, then air dry thoroughly
before replacing.
Replace the door by inserting the tabs on the left side and snapping the
right side into place.
Cleaning The Inner & Outer Circular Filters
9
1.
2.
3.
4.
Cleaning the Post-Motor Filter
1.
2.
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
WARNING:
To reduce the risk of
injury from moving parts,
turn off vacuum cleaner
and disconnect Power
Plug from electrical outlet.
5.
6.
3.
4.
Cleaning the Pre-Motor Filter
1.
2.
3.
Post-Motor Filter
Pre-Motor
Filter