Filter
Top Products
www.bissell.com 800.237.7691
11
Maintenance and care
Check rotating floor brush
and drive belt cont.
4. Grasp rotating floor brush at both ends
and lift.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris from
motor pulley and drive belt areas.
7. Check drive belt carefully for wear,
cuts or stressed areas.
8. Check air passageway for obstructions.
Remove debris from this area.
Replace drive belt
Use only genuine BISSELL style 9 replacement
belts (#32074) in your BISSELL Velocity
Bagged vacuum.
1. Unplug the cleaner from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of Check rotating
floor brush and drive belt), grasp old drive
belt and remove from motor pulley. Discard
old drive belt.
3. Place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
4. Place ends of rotating floor brush down
into slots on sides as shown.
5. Turn rotating floor brush by hand several
times in the direction of motor pulley.
If properly installed, the drive belt will
center itself on the rotating brush.
6. Reposition brush cover and screw back
into place.
Motor Pulley
Air Passageway
Motor
Pulley
6.
8.
4.