Filter
Top Products
16
w ww.b is se ll .c om
5
The only tool you'll need to assemble your
vacuum cleaner is a Phillips head screwdriver.
1. Slide upper handle into lower handle by
pushing forward. Insert two long screws into
the holes marked with arrows and tighten
both until snug.
2. Attach hose rack by placing the rack over
the center back portion of the vacuum.
Be sure to feed the power cord through
the hole in the center of the rack. Line up
both screws holes and use the two smaller
screws to attach. Tighten both until snug.
3. Attach hose by placing the tabbed end of
the hose cuff into the opening on the bottom
left side of the vacuum. Make sure the tab
on the hose cuff and the hole in the opening
line up and snap into place. Place the
working end of the hose into the opening
on the lower right side of the vacuum. Push
down firmly until it locks into place.
4. Arrange the hose so it lays between the
vacuum and the rack.
5. Store the TurboBrush on the front of the handle
by aligning the slot on the bottom with the tab
on the handle. Snap into place.
6. Store the combination brush in the slot on the
back of the vacuum as shown.
7. Store the extension wand in the storage area
on the side of the vacuum. The crevice tool is
stored inside the extension wand.
Assembly
1
2a
3
5
6-7
2b
Telescoping
Extension
Wand