Filter
Top Products
9
w ww.b is se ll .c a 1 -8 00 -2 63 -2 53 5
Operations
Bag change indicator
The bag change indicator is located between
the power button and the automatic cord
rewind button. If the bag change indicator turns
orange while you are vacuuming, the dust bag
needs to be replaced. The dust bag may appear
to be full or only partially full depending upon
the type of debris picked up. Fine particles can
block the airflow in the dust bag and reduce
suction before the dust bag is full. If the bag
change indicator remains orange, even after
changing the dust bag, turn the vacuum off and
check for a clog in the hose or tools.
Dust bag replacement
1. Unplug the vacuum from electrical outlet.
2. Disconnect hose
3. Open the dust bag compartment by lifting up
on the latch on the door on the front of the
vacuum.
4. Lift out the dust bag holder and dust bag.
5. Release the dust bag from the holder by
pressing the dust bag holder clip and pulling
the dust bag out of the holder. Discard the
used dust bag.
6. Slide the new dust bag into the holder by
inserting the dust bag into the tabs located
at the bottom of the holder. Then press the
dust bag holder clip, insert the dust bag and
release the dust bag holder clip to hold the
dust bag in place.
7. Place holder and new dust bag back into
the dust bag compartment, making sure
the entire bag is tucked in below the seal
gasket.
8. Close dust bag compartment door and press
down gently until it locks into place.
NOTE: The dust bag compartment door will
not close without the dust bag in place.
9. Reconnect hose.
3.
4.
5
WARNING: To
reduce the risk of electric
shock, turn power switch OFF
and disconnect plug from
electrical outlet before
performing maintenance or
troubleshooting checks.