Filter
Top Products
Snap the Telescoping Extension Wand, Crevice Tool,
and Combination Tool into storage clips as shown.
On Board TurboBrush
®
(Select Models Only)
The TurboBrush Bracket slides onto the Hanger on
the front of the Handle. Attach the Bracket by
aligning the slots with the rectangular part on the
Hanger as shown and pulling down until it is locked
into place.
Note: If you do not wish to store the TurboBrush
on your Lift-Off vacuum, the Bracket may be
hung on a wall for storage and the Hanger may
be removed from the vacuum.
Place the TurboBrush in the Bracket by aligning
the small holes near the brush roll with the tabs
at the bottom of the Bracket and snap the TurboBrush
into place.
The Power Switch is located just below the handle
on the front of the Detachable Canister. Push the
rocker switch “ON” (I) to vacuum, and “OFF” (O)
when cleaning is complete.
The Brush Switch is located just below the handle
on the front of the Detachable Canister next to
the Power Switch. This switch turns the Rotating
Brush on and off. The Brush Switch should be in
the “ON” (I) position for normal carpet cleaning.
You may want to turn the Brush Switch “OFF” (O)
for bare floor cleaning or other delicate surfaces.
Note: Your BISSELL Lift-Off Revolution vacuum
is equipped with a special internal switch that
turns the Rotating Brush off whenever the unit is
in the Upright position.
Upright – For storage and above floor cleaning with tools.
Normal Cleaning – Press the Handle Release Pedal
with your foot to recline.
3.
Attach Vacuum Hose and Tools Continued
6
4.
Power Switch/Brush Switch
1.
2.
Combination
Tool
Telescoping
Wand
Crevice Tool
CAUTION:
Before using your vacuum, make
sure that the Dirt Container and
Upper Tank are in locked position
and that all filters (Upper Tank,
Pre-Motor and Post-Motor) are
in place. Do not operate your
vacuum without these filters.
Handle Positions
Brush
Power
Tip:
Your vacuum features a Quick-Release
Cord Wrap. To remove the Power Cord
quickly and easily, rotate the Upper Cord
Wrap towards floor, and slip Power Cord
from Upper and Cord Wraps..
How To Use Your Vacuum
TurboBrush
®
ug603-5567_3760-6850_905.indd 6ug603-5567_3760-6850_905.indd 6 10/3/05 3:52:46 PM10/3/05 3:52:46 PM