Bissell 4220 Vacuum Cleaner User Manual


 
How To Use This Guide
This User’s Guide has been designed to help
you get the most satisfaction from your BISSELL
Vacuum. You’ll find assembly and operating
instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this Guide thoroughly before
assembling your vacuum cleaner.
Pay particular attention to the product diagram,
assembly instructions, and part names. Locate
and organize all parts before assembly. Familiarize
yourself with the parts and where they fit.
Following this User’s Guide will greatly enhance
your ability to get the most performance from your
BISSELL Vacuum for many years.
The only tool you’ll need to assemble your vacuum
cleaner is a screwdriver.
Locate the vacuum Handle and remove the screw
packet taped to the base of the Handle.
Stand the vacuum upright and slide the base of
the Handle firmly into the grooves at the top of the
vacuum body.
Check to be sure the Handle is fitted to the vacuum
body. If there is a gap in front, continue to push firmly
until the Handle is flush.
Insert the two screws from the screw packet into the
existing holes. Tighten securely with a screwdriver.
Position the Twist ‘n Snap Hose
assembly on the
vacuum and line up the tabs on the base of the hose
with the corresponding notches. Turn the Twist ‘n Snap
Hose to the right to lock into place.
Slide the end of the Hose Grip onto the Hose Grip Base.
Place the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively
unless the Hose is firmly attached to the base.
1.
Attach Handle To Vacuum
5
How To Put It Together
2.
3.
4.
Attach Vacuum Hose and Tools
1.
WARNING:
Plastic film can be
dangerous. To avoid danger
of suffocation, keep away
from babies and children.
2.
ug603-5567_3760-6850_905.indd 5ug603-5567_3760-6850_905.indd 5 10/3/05 3:52:45 PM10/3/05 3:52:45 PM