Filter
Top Products
Line up the tabs on the base of the Twist ‘n Snap
Hose with the corresponding notches on the hose
collar as shown.
Turn the Twist ‘n Snap Hose to the right to lock the
hose into place.
Grasping the Quick Reach Handle, slide the end of
the Hose Wand onto the Hose Wand Base. Snap the
Hose into the Hose Clip.
NOTE: The Powerfoot will not operate
effectively unless the Hose Wand is
firmly attached.
Slide the Extension Wand and the Crevice Tool
together into the storage clip as shown.
Slide the Dusting Brush/Upholstery Tool into the storage clip
as shown.
Attach the TurboBrush by aligning the small holes near
the brush roll with the tabs at the bottom of TurboBrush
housing. Snap TurboBrush into place as shown.
4.
Attach Vacuum Hose and Tools
6
5.
NOTICE:
The Floor Brush will continue to rotate
while you use your vacuum for above
floor cleaning. To prevent carpet
damage, do not lean on the vacuum or
let the Powerfoot tilt forward
.
3.
6.
Select Models Only
1.
2.
CAUTION:
Before using your vacuum,
make sure that the Dirt
Container and Upper Tank are
in locked position and that all
filters (UpperTank, Pre-Motor
and Post-Motor) are in place.
Do not operate your vacuum
without these filters.