Filter
Top Products
12
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
Check Air Passageway for obstructions. Remove debris
from this area.
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum cleaner
(Steps 1-4 of check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley.
Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end
over Rotating Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on
sides as shown.
Turn Rotating Floor Brush by hand several times in the
direction of Motor Pulley. If properly installed, Drive Belt
will centre itself on Rotating Brush crown.
Reposition Brush Cover and screw or snap back into place.
Check to be sure all screws or latches are secure.
Unplug cleaner from electrical outlet.
Using a screwdriver, remove the two screws as shown
and lift off the lens.
Remove the bulb from the socket by grasping bulb and
pulling straight out. Install the new bulb by pushing it
gently into the socket until the bulb snaps into place.
Reposition lens and secure with the two screws.
Select Models Only
The TurboBrush should be checked regularly for clogs
or debris wrapping around the brush roll.
Unplug vacuum from electrical outlet.
If a clog is present or debris is visible, unscrew the two
screws on the back of the
TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the brush roll, remove the screw
located by the brush roll with a Phillips head screwdriver.
Lift the belt cover. Remove the brush roll from the drive
belt and clean debris.
1.
Replace Lightbulb
2.
3.
4.
Maintaining TurboBrush
Replace Drive Belt
Check Rotating Floor Brush and Drive Belt Continued
1.
2.
3.
4.
5.
6.
4.
5.
6.
7.
8.
Air Passageway
Motor Pulley
1.
2.
3.