Filter
Top Products
Determine the light bulb type of your vacuum:
Standard Bulb (#203-1297) – approximately 1” long, flat end
Large Bulb (#203-1007) – approximately 2” long, round end
Standard Bulb – remove the bulb from the socket by grasping
bulb and pulling straight out. Install the new bulb by pushing it
gently into the socket until the bulb snaps into place.
Large Bulb - remove the bulb from the socket by pushing
bulb in gently and turning it towards brush. Install the new
bulb by pushing it gently into the socket and turning away
from the brush.
Reposition lens by inserting the tab on left side and then
pushing the right side back into place.
Select Models Only
The TurboBrush should be checked regularly for
clogs or debris wrapping around the brush roll.
Unplug vacuum from electrical outlet.
If a clog is present or debris is visible, unscrew the two
screws on the back of the TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the brush roll, remove the screw
located on the belt cover. Lift the belt cover. Remove the
brush roll from the drive belt and clean debris.
Reposition the drive belt on the brush roll. Place ends
of brush roll in slots on sides as shown. Reposition belt
cover and secure with shorter screw. Reposition faceplate
and secure with two longer screws.
Low suction, poor pickup, or no suction may be due to
a clog in the vacuum cleaner. If you notice a change in
the sound of the motor or a reduction in the spinning
action in the Dirt Container, check for clogs.
Unplug cleaner from electrical outlet.
Empty Dirt Container.
3.
Replace Lightbulb Continued
11
4.
5.
1.
2.
TurboBrush Maintenance
Standard Bulb
Large Bulb
Clearing Clogs
1.
2.
3.
4.
Belt Cover