Filter
Top Products
w w w . b i s s e l l . c o m
9
Maintenance and care
4. Replace the filter with a new HEPA media
filter by having the tab, connected to the
filter frame, on top and inserting the filter
frame straight down into the filter holder.
NOTE: The filter frame should be
placed so the protective frame is vis-
ible.
5. Place dust bag holder and dust bag into
the dust bag compartment, making sure the
entire bag is tucked in below the seal
gasket.
6. Close dust bag compartment door and
press down gently until it locks into place.
The post-motor micro filter assists in
the filtration process to return clean
air to the room.
1. Unplug the vacuum from electrical outlet.
2. Open dust bag compartment by lifting up
on the latch on the door at the front of the
vacuum, until the door locks into place.
3. Remove the post-motor micro filter from
indentation, which is located towards the
back of the dust bag compartment near
the hinges of the door.
4. If there is no visible wear and tear and/or
imbedded dirt, it is acceptable to clean the
filter by hand washing it with warm water.
A mild detergent can be used if desired.
Allow the filter to air dry thoroughly before
replacing.
NOTE: It is recommended to always
replace the post-motor micro filter
after every fifth replacement of the
dust bag.
5. Replace the post-motor micro filter back
into indentation, with the white side facing
down.
6. Close the dust bag compartment door and
press down gently until it locks into place.
Replacing the HEPA media pre-motor filter continued
Replacing the post-motor micro filter
Post-Motor
Micro Filter
3.
Tip:
Change HEPA media filter every
6 months. Otherwise, efficiency
and air permeability will be
reduced.
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.