Filter
Top Products
www.bissell.com 800.237.7691
Operations
8
Power cord storage
When you have finished using your
BISSELL CleanView Helix, return it
to the upright position and store the
power cord.
1. Turn vacuum cleaner off.
2. Unplug power cord by grasping the
polarized plug (NOT the cord) and
disconnect from outlet.
3. Loop power cord around cord wraps
on side of vacuum cleaner.
4. Clip molded plug to power cord to secure.
To maintain maximum cleaning
performance, the following
maintenance steps must be performed:
1. Empty the dirt container when the dirt
reaches the “Full” line on the side.
2. Check the inner and outer circular filters
and the pre-motor filter at least once a
month and clean or replace as needed.
3. Replace the post-motor filter every six months.
Note: More frequent filter cleaning
or replacing may be necessary if
you are vacuuming new carpet,
fine dust or have allergy concerns.
Follow the instructions on the
following pages to perform these
simple maintenance steps.
Empty Dirt Container
The dirt container needs to be emptied
when the dirt reaches the “Full” line
on the side of the container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal lever to the
"Unlock" position.
3. Grasp dirt cup portion handle and pull
straight out to remove from vacuum.
4. Empty dirt into garbage container.
NOTICE:
While vacuuming, certain carpets
and low humidity conditions may
generate small static discharges.
The discharges are entirely harmless
and are not associated in any way
with the main power supply.
Tip:
For maximum cleaning
performance, check
and clean or replace
all filters as suggested.
WARNING:
To reduce the risk of electric
shock, turn power switch OFF
and disconnect polarized plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
Full Line
Lock Position
Unlock Position
2.
Maintenance and care