Filter
Top Products
www.bissell.com 800.237.7691www.bissell.com 800.237.7691
12
Clearing a clog
Low suction or poor pickup may be
due to a clog in the vacuum cleaner.
If you notice a change in the sound
of the motor or a reduction in the
spinning action, check for clogs.
1. Unplug cleaner from electrical outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Check the suction inlet for a clog.
5. Grasp the quick reach handle and
lift hose wand to separate from the
suction opening. Check for a clog
in the base, the wand or the hose.
6. Remove the screw attaching the hose
wand base to the vacuum. Straighten the
hose wand base and unclog with long,
narrow object such as a broom stick.
7. If the clog persists, follow the
instructions for Checking the rotating
floor brush on page 10 and inspect
the air passageway for obstructions.
Replace light bulb
Use only BISSELL Replacement Bulbs
in your BISSELL CleanView Helix.
selected models only
1. Unplug cleaner from electrical outlet.
2. Using a flat screwdriver, table knife or
coin, insert into the slot on the right of
the lens and gently push inner latch to
the left as shown to remove the lens.
3. Reposition lens by inserting the tab
on left side and then pushing the right
side back into place.
3.
4.
6.
2.
3.
Maintenance and care
Suction Inlet
Remove Screw