Filter
Top Products
www.bissell.com
Maintenance and care
8
To maintain maximum cleaning
performance from your BISSELL
Cleanview cyclonic bagless vacuum,
perform these simple maintenance
steps.
1. Empty the dirt container when the dirt
reaches the “Full” line on the side.
2. Check the inner and outer circular
filters, and the pre-motor filter at least
once a month and clean or replace as
needed.
3. Replace the HEPA media post-motor
filter* every three to six months.
Note: More frequent filter cleaning
or replacing may be necessary if
you are vacuuming new carpet,
fine dust, or have allergy concerns.
Follow the instructions on the fol-
lowing pages to perform these
simple maintenance steps.
Emptying dirt container
The dirt container needs to be emptied
when the dirt reaches the “Full” line
on the side of the container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal lever to the
"Unlock" position.
3. Grasp handle and pull dirt container
straight out to remove from vacuum.
4. Empty dirt into garbage container.
5. Put dirt container back in the vacuum
and slide the lever to the "Lock"
position.
Note: The dirt container may be
washed in warm water with a mild
detergent. Remove the filter cup from
the bottom before washing. Make
sure it is completely dry before
reassembling with the filter cup.
WARNING:
To reduce the risk of electric shock, turn
power switch OFF and disconnect plug
from electrical outlet before performing
maintenance or troubleshooting checks.
Tip:
For maximum cleaning
performance, check
and clean or replace
all filters as suggested.
Lock Position
Unlock
Position
Full Line
*The Filter Media, not the vacuum as a whole, complies with the High Efficiency
Particulate Air (HEPA) filter specification (EN 1822-1:2009).