Bissell 28F4 Carpet Cleaner User Manual


 
www.bissell.com
Assembly
The only tool you’ll need to assemble
your vacuum cleaner is a screwdriver.
Attach handle to vacuum
1. Locate the vacuum handle and remove
the screw packet taped to the base of
the handle.
2. Stand the vacuum upright and place the
handle on the top of the vacuum body.
3. Insert the screws into the existing holes
on each side. Tighten securely with a
screwdriver.
Attach vacuum hose and tools
1. Attach the Twist ‘n Snap hose by
lining up the tabs on the base with the
corresponding notches on the back of
the vacuum.
2. Turn the Twist ‘n Snap hose to the right
to lock the hose into place.
3. Grasping the Quick Reach handle, slide
the end of the hose wand into the hose
wand base. Snap the hose into the hose
clip.
NOTE: The powerfoot will not
operate effectively unless the hose
wand is firmly attached.
4. Slide the extension wand and the crevice
tool together into the storage clip on the
side of the vacuum.
5. Snap the combination tool into the
storage clip on the back of the vacuum.
6. Select models only: The TurboBrush
tool bracket slides into the front of the
handle. Attach the bracket by aligning
the pegs with the holes on the handle
and pulling down until it locks into
place.
7. Select models only: Place the
TurboBrush tool in the bracket by aligning
the bottom of the bracket with the opening of
the brush roll and snap the TurboBrush tool
into place.
WARNING:
Plastic film can be dangerous. To
avoid danger of suffocation, keep
away from babies and children.
5
Inner and
Outer
Circular
Filters