Filter
Top Products
11
www.bissell.com 800.237.7691
Operation
Carpet cleaning
1. Plug the deep cleaner into a proper outlet.
Set ReadyTools dial to the Floor Cleaning
setting. Turn the power on by pressing the
red power switch on the back of the unit
with your foot. Turn heater switch (located
on side of unit) to the on position. Allow one
minute for the built-in heater to warm up
before cleaning.
NOTE: The ProHeat will be fully warmed
and will provide optimal performance after
a minute of continuous heated cleaning.
2. With your foot, press the gray handle release
lever located on the back of unit below
water tank to detent handle.
3. While pressing the spray trigger, make one
slow forward wet pass and another back.
Let the built-in heater, BISSELL advanced
deep cleaning formula, and DirtLifter
PowerBrush do the work for you.
Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over the
same area to remove any residual dirty
water and aid in drying.
5. Repeat cleaning passes until solution
being suctioned up appears clean. Continue
passes without pressing the trigger until
you can’t see any more water being
suctioned up.
Tip: Thorough vacuuming
before deep cleaning will prevent
early clogging of the lint trap.
WARNING:
To reduce the risk of fire
and electric shock due to
internal component
damage, use only BISSELL
cleaning fluids intended for
use with the deep cleaner.
Non-BISSELL cleaning
solutions may harm the
machine and void
the warranty.
Power Switch
Heater
Switch
Handle Release
ug120-4078_25A3_908.indd 11 10/14/08 1:21:05 PM