Filter
Top Products
5
www.bissell.com 800.237.7691
Your unit will require no tools to put together.
1. Remove the dirt tank by pulling up on both
handles to unlatch. Lift upper half of unit
to remove.
2. Remove all accessories and parts stored in
the bottom of the tank prior to use.
3. If the round funnel comes out of dirt tank,
set back inside the dirt tank before reas-
sembling vacuum.
4. To reassemble, place the top of the unit on the
dirt tank so the edges fit together and latch
handles to secure top and bottom of unit.
5. Mount to wall (see instructions below).
Mounting & installation
Only use when properly mounted on the wall.
When mounting to a stud, use the (3) center holes.
Mounting on drywall or plaster wall with stud
(fasteners included)
1. Locate a stud in your dry wall and drill a
1/8” pilot hole.
2. Mount the bracket with a #10-16 x 1-3/4”
screw, starting at the center hole.
3. Ensuring your bracket is aligned correctly
with the stud; drill a second pilot hole using
the next hole as a guide. Securely fasten
with a screw.
4. Repeat step 3 for remaining hole.
Note: Mount near a wall outlet, making sure
the cord provided will reach the outlet.
5. Mount the unit by making sure the two
square slots on backside of unit are sitting
on the two hooks on the mounting bracket.
Assembly
WARNING:
Do not mount unit
directly into dry wall.
ALWAYS locate a stud.
ATTENTION:
Make sure the end of the
bracket with the smaller
width faces up.
Use (3) Middle Holes
To Mount Bracket
ug110-4046_18P0_408.indd 5ug110-4046_18P0_408.indd 5 4/17/08 4:43:01 PM4/17/08 4:43:01 PM