Filter
Top Products
5
How to use your BISSELL Steam ‘n Clean II
How to use this guide
This User’s Guide has been designed to help you
get the utmost satisfaction from your BISSELL Steam ‘n
Clean II hand-held steam cleaner. You’ll find assembly
and operating instructions of all cleaning tasks, safety
precautions, pre-cleaning tips, maintenance and
troubleshooting instructions.
Pay particular attention to the parts diagram, assembly
instructions, and part names. Familiarize yourself with
the tools and how they are used. Following this User’s
Guide will greatly enhance your ability to get the most
performance from your BISSELL Steam ‘n Clean II for
many years.
Your Steam ‘n Clean II comes assembled and ready to
use. The drawing on page 4 and part names may come
in handy should you need to order a part.
The Water Tank is the blue tank at the end of the Steam
‘n Clean II.
Remove the Tank by releasing the Tank Latch
and sliding the Water Tank off the unit.
Remove the Water Fill Cap by grasping the tab
on the Water Fill Cap and pulling it off the
Water Tank.
Fill Water Tank completely with cool tap
water,* and replace Water Fill Cap.
Reattach Water Tank sliding tank into position
and latching into place.
*Note: You may substitute distilled or
demineralized water for tap
water. Doing so may reduce the
need to change the Water Filter
to just once a year.
Do not add anything except cool water
or you will cause damage to the heat-
ing element and void your warranty.
1.
2.
Water Tank
3.
4.