1. With your foot, press the red Power Switch
[located in foot of unit] ON.
2. With foot, press the Detent Lever on right side of
Lower Body.
3. Depress Spray Trigger to spray cleaning solution.
Do not overwet.
4. To suction up water, repeat motion over same
area without depressing Trigger.
5. Repeat Steps 3 and 4 until no more dirt can
be removed.
6. Continue to clean entire carpet, working in
3’ x 4’ sections.
7. Empty the Collection Tank when dirty water reaches
the full line, or when the Clean/Solution Tank is
empty. See page 8 for instructions.
8. If Floor Nozzle stops spraying, turn Power Switch
OFF and check water and cleaning solution levels.
Refill if needed.
1. Attach Hard Floor Tool to Unit.
2. Remove the Collection Tank (refer to #3a and b in
the Routine Maintenance section on page 8)
A. For 1770/1970 series it is necessary to
remove the Cross Action Brush first.
Using your thumbs squeeze the 2 grey tabs
towards the outside of the unit. Push down
at the same time and release the Cross
Action Brush.
3. Attach the Hard Floor Tool by hooking it into the
front of the removable nozzle and swinging it
down until the tabs pop into place.
4. Replace the Collection Tank. Be sure to attach the
2 latches.
5. Fill Clean/Solution Tank with BISSELL Hard Floor
Solutions™ to FORMULA fill line.
6. Fill Clean/Solution Tank with hot (not boiling) tap
water to the WATER fill line.
7. Follow steps 1-8 in Deep Cleaning section above.
Carpet Cleaning
7
www.bissell.com 800.237.7691
Tip:
It is recommended
that every time your
Clean/Solution Tank is
emptied of solution that
you empty the contents
of the Collection Tank. If
the Collection Tank gets
too full, you may begin
to see foam
spitting out of the vent
cover. When this
happens you will know
it is time to empty the
Collection Tank.
Hard Floor Cleaning
3
3
1770/1790 series
2080/2090 series
ug603-5603_1770_206.indd 7
ug603-5603_1770_206.indd 7
2/28/06 4:27:25 PM
2/28/06 4:27:25 PM