Filter
Top Products
Troubleshooting
Reduced spray or no spray.
Possible Cause Remedies
1. Bladder may be empty. 1. Refill bladder with hot tap water.
2. SmartMix tank may be empty. 2. Fill with BISSELL deep Cleaning
formula for cleaning. Fill with
water if rinsing.
3. The filter may be clogged. 3. Clean out flow indicator filter,
page 12.
4. Tanks may not be seated properly. 4. Turn power OFF (O); remove &
reseat tanks.
5. Pump may have lost prime. 5. Turn power OFF (O); after 1
minute turn ON and press
trigger.
6. The Pump belt may be broken. 6. Turn on the machine and check to see
that the DirtLifter PowerBrush turns. If
it does not, refer to #1 below.
DirtLifter PowerBrush does not turn.
Possible Cause Remedies
1. The brush belt or pump belt 1. Turn the machine OFF (O) and unplug
is off or broken. from the outlet. To check if the brush
belt or pump belt has broken, you
will need a flat head screwdriver.
Insert the blade end into the lower
slot of the belt access door to release
the lower snap. If necessary, insert
the blade end into the upper slot to
release the upper snap. Examine the
belt for breakage. If broken, please
refer to Replacement Parts on page 19
before calling Consumer Services.
Complete installation instructions
will accompany the replacement belt.
Insert
Screwdriver
Blade Here
Lift Here
17
www.bissell.com 800.237.7691
ug310-5941_7901bi_608.indd 17 6/24/08 1:39:07 PM