Filter
Top Products
Maintenance and care
Cleaning with attachments (continued)
A. Check manufacturer’s tag before
cleaning. “W” or “WS” on the tag
means you can use your ProHeat. If
the tag is coded with an “X” or an “S”
(with a diagonal stripe through it), or
says “Dry Clean Only”, do not proceed
with any deep cleaning machine.
Do not use on Velvet or Silk. If
manufacturer’s tag is missing or not
coded, check with your furniture
dealer or manufacturer.
B. Check for colorfastness in an
inconspicuous place.
C. If possible, check upholstery stuffing.
Colored stuffing may bleed through
fabric when wet.
D. Plan activities to allow upholstery time
to dry.
E. Vacuum thoroughly to pick up loose
debris and pet hair. Use a vacuum with
a brush attachment and a crevice tool
to clean in fabric folds.
2. Follow the instructions on page 9 for filling
the water tank and the formula tank.
3. Set ready tools dial to the tools setting. This will
allow spray and divert the suction to the hose.
*SmartTemp heats the cleaning solution for
carpet and hard floor application only. It
does not heat solution sprayed through the
accessory tools.
4. Set SmartMix dial to normal.
5. Attach the cleaning tool to the end of the hose.
6. Plug in and turn on the power switch.
7. Clean by pressing the trigger to spray solution
onto the area to be cleaned. Slowly move the
tool back and forth over the soiled surface.
Release the trigger to suction soiled water.
Continue to clean in the area, working in small
sections, until no more dirt can be removed.
Rinse (optional) and suction as needed.
Caution: Do no overwet.
8. When cleaning is complete, remove and
rinse tools in clean, running water.
9. Coil hose around the tool caddy.
Manufacturer’s tag
WARNING:
To reduce the risk of
injury, be extra careful
when cleaning stairs.
Make sure machine is
secure and level.
13
www.bissell.com 800.237.7691
ug310-5941_7901bi_608.indd 13 6/24/08 1:39:04 PM