Filter
Top Products
17
Machine Preparation
Set up machine following instructions in the Features
section, pages 6-11. Be sure to thoroughly rinse out any
remaining Fiber Cleansing Formula from the SmartMix
bottle to prevent slippery linoleum, vinyl, and tile floors.
Use BISSELL Floor Cleansing Formula in
the SmartMix tank.
Check ReadyTools Dial - it should be set on Floor Cleaning.
Choose the SmartMix setting to match the cleaning job.
Plug into a proper outlet and turn Power Switch ON. Turn
SmartTemp switch ON. The SmartTemp Ready Light
illuminates and ProHeat ClearView is ready to clean.
Slowly move the machine nozzle with Bare Floor Tool
forward and back over soiled surface one time while
pressing the trigger. Caution: Do not overwet.
Repeat the motion without pressing the trigger using the
Bare Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
Allow about 30 minutes for the floor to dry completely.
When the cleaning job is complete refer to the
Maintenance/Storage section on page 18.
To remove Bare Floor Tool gently bend long tab (right side)
outward and pull tool down away from nozzle. Rinse
thoroughly, dry and store.
1.
2.
3.
4.
1.
2.
3.
5.
6.
Cleaning Bare Floors Continued
Bare Floor Cleaning Technique
When filling bottle or
storing unit, set
dial to:
4.