Bissell 1623 Carpet Cleaner User Manual


 
9
www.bissell.com 800.237.7691
1. Turn power switch OFF. Remove the 2-in-1 water
tank from the base using the tank carry handle.
Carry the tank like a bucket to a utility sink or
outside where you will dispose of the collection
water. Remove the top of the tank by rotating the
handle forward to unlatch lid and lifting lid off tank.
2. Empty collection water from bottom of tank.
3. After each use, remove and rinse the lint
screen located on the tank lid.
4. If nozzle needs to be cleaned: remove by grasping
handle at the top and pulling forward. Clean
removable nozzle by rinsing under running water.
5. When finished, replace nozzle by slightly
raising front of machine to line up slots on the
base with the hooks on nozzle. Attach at base
first and then click nozzle into place.
NOTE: If nozzle is not attached properly loss
of suction will occur.
6. To continue carpet cleaning, refer back to
pages 7 through 8, beginning with “Fill the
2-in-1 water tank” on page 7.
If cleaning is complete, refer to the “Maintenance
and care” section below.
Ready Tools™ cleaning with attachments
Your deep cleaner comes equipped with a hose
and at least one attachment for cleaning stairs,
upholstery, and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1. Check manufacturer’s tag before cleaning.
“W” or “WS” on the tag means you can use
your PowerSteamer. If the tag is coded with
“X” or “S” (with a diagonal strike through),
or says “Dry Clean Only,” do not proceed. Do
not use on velvet or silk. If manufacturer’s
tag is missing or not coded, check with your
furniture dealer.
2. Check for colorfastness in an inconspicuous
place.
3. If possible, check upholstery stuffing.
Colored stuffing may bleed through fabric
when wet.
4. Plan activities to give upholstery time to dry.
Operation
2.
3.
1.
5.
Lint Screen
Empty the 2-in-1 water tank/ clean removable nozzle
4.
Manufacturer’s tag
ug120-4073_1623_908.indd 9 10/14/08 12:59:39 PM