Filter
Top Products
1
FAN SAFETY
PLEASE READ AND SAVE
THESE IMPORTANT
SAFEGUARDS.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury
to persons, including the following:
1) Read all instructions before using the appliance.
2) To avoid fire or shock hazard, plug the appliance directly into a
120 V AC electrical outlet.
3) Keep the cord out of heavy traffic areas. DO NOT let the cord hang
over the edge of a table or counter. To avoid fire hazard, NEVER
put the cord under rugs, near heat registers, radiators, stoves, or
heaters.
4) To protect against electrical hazards, DO NOT immerse in water or
other liquids. Do not use near water.
5) Close supervision is necessary when any appliance is used by or
near children, or by disabled people.
6) Always unplug the fan before moving it, putting on or taking off
parts, cleaning, or whenever the fan is not is use. Be sure to pull
by the plug and not the cord.
7) Avoid contact with moving parts. DO NOT operate without fan
grills properly in place.
8) DO NOT operate any appliance with a damaged cord or plug, if
motor fan fails to rotate, after the appliance malfunctions, or if it has
been dropped or damaged in any manner. Return appliance to
manufacturer for examination, electrical or mechanical adjustment,
or repair.
9) DO NOT operate in the presence of explosive and/or flammable
fumes.
10) Use appliance only for intended household use as described in this
manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons. The use of attach-
ments not recommended or sold by Bionaire may cause hazards.
11 ) DO NOT use outdoors.
12) Always use on a dry, level surface.
13) Keep unit away from heated surfaces and open flames.
14)WARNING: To reduce the risk of fire or electric shock, DO NOT use
this fan with any solid-state speed control device.
15) DO NOT attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void your warranty. The inside
of the unit contains no user serviceable parts. All servicing should
be performed by qualified personnel only.
BSF 1731 9/00
2
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current) PLUG (a plug
having one blade wider than the other). This plug will fit into the power outlet only one
way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact qualified personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY.
BASE/POLE ASSEMBLY
Step 1: Insert lower pole into the base until the threaded end of the pole
protudes through the opening in the center of the base. Twist the pole
clockwise until locked.
Step 2: Turn the base upside down and place the weighted insert into
the base by aligning it between the two parallel ribs. Secure the base,
weight, and pole system together by tightening the weight nut to the
threaded portion of the pole. Place the base on the floor, right side up.
Step 3:Replace the height adjustment knob over the pole, slide it down
the pole, and secure it to the base by turning clockwise.
ASSEMBLY INSTRUCTIONS
A. Grill Hub
B. Front Grill
C. Fan Blade Nut
D. Fan Blade
E. Rear Grill
Mounting-Ring
F. Rear Grill
G. Motor Shaft
H. Motor Housing
I. Upper Pole
J. Height Adjustment Knob
K. Lower Pole
L. Base Insert
M. Base
N. Weighted Insert
O. Weight Nut
P. Fixed Screw
Q. Grill Ring
R. Remote Control Housing
S. Fan Post Screw
T. Remote Control
A
B
C
D
E
F
G
H
I
J
K
M
N
O
P
Q
L
Figure 1
BSF1731
Figure 2
BSF1731RC
H
I
J
K
G
T
S
R
PLEASE READ AND SAVE THESE
IMPORTANT SAFEGUARDS.
BSF1731RC/RC-CN_eng.qxd 12/31/01 4:24 PM Page 2