Filter
Top Products
3.7 Delay of Start/Stop button has been reduced for embroidery
Delay time reduced from 800ms to 200ms
3.8 Thread breakage during jump stitches
The tension was closed during the module movement when the function “cutting of jump stit-
ches” was disabled. This potentially caused thread breakage. This has been resolved.
3.9 Stitching “without thread”, is displayed in embroidery mode
As is in sewing mode (in setup), the selected “no thread” mode will be displayed.
4 IMPORTANT POINTS
4.1 Hoop calibration
Calibration of hoops has to be done after updating the BERNINA 830.
4.2 Feedback issues
Please inform BERNINA (standard information way) about any unusual crashes, error messages
and malfunction in form of a log file. Please document every step of the application and manipu-
lation that led to the malfunction so that the process can be reproduced.
4.3 Free memory
If there is nothing stored on the sewing machine memory and the free memory counter does not
show 100%, the software version has to be updated again (this will free all allocated memory
not used).
13/14, 04.11.2009