Filter
Top Products
Manual 2100-373
Page 17
FAN BLADE SETTING DIMENSIONS
Shown in the drawing below are the correct fan blade
setting dimensions for proper air delivery across the
outdoor coil.
Any service work requiring removal or adjustment in
the fan and/or motor area will require that the
dimensions below be check and blade adjusted in or out
on the motor shaft accordingly.
REMOVAL OF THE FAN SHROUD
1. Disconnect all power to unit.
2. Remove the screws holding both grilles, one on each
side of unit, and remove grilles.
3. Remove screws (9) holding fan shroud to condenser
and bottom.
4. Unwire condenser fan motor.
5. Slide complete motor, fan blade, and shroud
assembly out the left side of the unit.
6. Service motor/fan as needed.
7. Reverse steps to reinstall.
REFRIGERANT CHARGE
The correct system R-22 charge is shown on the unit
rating plate. Optimum unit performance will occur with
a refrigerant charge resulting in a suction line
temperature
(6” from compressor) as shown in Table 7.
The suction line temperatures in Table 7 are based upon
80° F dry bulb/67° F wet bulb (50% R.H.) temperature
and rated airflow across the evaporator during cooling
cycle.
FIGURE 11
TABLE 6
ledoM
noisnemiD
A
381HW
242HW
00.1
TABLE 7
(Temperatures °F)
ledoM
detaR
wolfriA
59
o
DO
erutarepmeT
28
o
DO
erutarepmeT
381HW
242HW
056
008
85-65
95-75
56-36
76-56
.P.S.E
HnI
2
O
,381HW
242HW
yrD/ teW
0.
1.
2.
3.
4.
5.
6.
0201
069
568
028
537
516
--
/
/
/
/
/
/
/
579
509
008
537
056
535
--
TABLE 8
INDOOR BLOWER PERFORMANCE
CFM
@
230V
TABLE 9
* Rated CFM and ESP on high speed tap
.
ledoM
detaR
*MFC
detaR
*PSE
dednemmoceR
egnaRwolfriA
381HW05604.527---575
242HW00802.059---007
Values shown are for units equipped
with standard throwaway filter or 1”
washable filter. Derate ESP by .15 for
2” pleated filter.
TABLE 10
MAXIMUM ESP OF OPERATION
ledoMPSE
381HW
242HW
00A
40A
80A
05.
05.
04.
242HW
00B
60B
05.
05.
242HW
00C
60C
05.
05.