Filter
Top Products
4
Pop-up Drain Installation
• Remove the plunger assembly (1, 2).
• Unscrew the drain outlet flange (3)
from the tee (8).
• Unscrew the tailpiece (9) from the tee
(8). Wrap the threads with plumbers’
thread tape and replace.
• Install the white, flexible sealing
gasket (4) to the flange (3). Sit it in
the sink outlet.
• From under the sink, install the black
mack gasket (5), white friction ring (6)
, and retainer nut (7) to the flange (3).
Do not tighten the nut against the
bottom of the sink at this time.
• Thread the tee (8) and tailpiece (9) to the flange. The pivot must face the faucet. If
necessary, turn the drain assembly.
• Tighten the retainer nut (7).
• Sit the plunger assembly in the drain (1,2).
• Install the horizontal rod (11) so that the end goes through the loop in the bottom of the
height adjuster (2).
• Install and hand tighten the pivot ball nut(13).
• Attach the swivel connector (12) to the end of the horizontal rod (13) .
• Attach the swivel connector to the end of the vertical rod (14). Position as desired, and
tighten with a small, flathead screwdriver.