Filter
Top Products
If using in an existing shower, remove the old showerhead:
· While holding the shower arm, remove the existing
showerhead by turning counter-clockwise with an adjustable
wrench.
· Thoroughly clean the threads on the shower arm with a wire
brush.
· Slide decorative rubber boot onto the shower arm, narrow
end first. Push it up and out of the way.
· Make sure that the self-sealing filter gasket is fully seated in
the showerhead by grasping the black tab and turning
clockwise as far as it will go without forcing it.
· Screw the showerhead onto the arm, taking care not to
cross thread.
· Finish tightening with wrench, taking care not to over-
tighten or showerhead and / shower arm may be
damaged. Turn on the water and check for leaks. Pull
boot down over showerhead ball joint.
Raindance Showerhead
28473XX1
Technical Data
Flow rate at 45 psi 2.5 gpm
Installation:
Make sure that the self-sealing filter gasket is installed in the inlet of the
showerhead.
The filter must be installed to protect against damage from debris.
Debris damage is not covered by the Hansgrohe warranty.
User Instructions
Change the spray mode by turning the
function ring until the index mark is next to
the name of the spray function.
function lever
Rain
Mix 1
Balance
Mix 2
Whirl
17 mm