Filter
Top Products
ca3051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
ELIMINATING/RETURNING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps using the valet/
override switch, following these steps.
1. Turn the ignition key ON the OFF.
2. Within 10 seconds of turning the ignition key OFF, press and release the
valet/override switch 3 times.
3. If, before step 1, the chirps were ON, then you will hear 2 short chirps,
which indicates the chirps are turned OFF.
4. If, before step 1, the chirps were OFF, then you will hear 1 short chirp,
which indicates the chirps are turned ON.
5. Whenever the system's power has been disconnected, the chirps will be
ON when power is reconnected.
ALARM DASH LED INDICATORS
RAPID FLASHING = PASSIVE ARMING
SLOW FLASHING = ARMED
OFF = DISARMED
ON SOLID = VALET MODE
4 FLASH...PAUSE = INTRUSION SHOCK SENSOR
3 FLASH...PAUSE = INTRUSION DOOR
2 FLASH...PAUSE = INTRUSION HOOD OR TRUNK
ALARM SIREN CHIRP INDICATION
1 CHIRP* = ARM
2 CHIRPS* = DISARMED
3 CHIRPS = ARMING WITH ENTRY POINT OPENED
4 CHIRPS = DISARM AFTER INTRUSION
CONTINUOUS = ALARM TRIGGERED
ALARM PARKING LAMP INDICATIONS
1 FLASH = ARM
2 FLASH = DISARM
3 FLASH = DISARM AFTER INTRUSION
CONTINUOUS FLASH = TRIGGERED
SYSTEM FUNCTIONS AT A GLANCE