Filter
Top Products
ca3051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
If the LED flashes 4 times...pause, 4 times...pause etc., then an intrusion
attempt was made by impact or a strong vibration that the shock sensor
detected. Check the vehicle for possible damage to the glass or body panels.
NOTE: The LED intrusion warning indications are stored in the system's
memory and will be erased when the ignition switch is turned on.
VALET/OVERRIDE SWITCH:
The valet switch allows you to temporarily bypass all alarm functions,
eliminating the need to hand your transmitter to parking attendants or garage
mechanics. When the system is in valet mode, all alarm functions are
bypassed, however the remote panic feature and remote door locks will
remain operational.
1. Enter the vehicle, and turn the ignition key to the ON position.
2. Press and hold the valet pushbutton switch until the dash mounted LED
turns on solid. The system will remain in the valet mode.
3. To return to normal operation, press and release the push button switch
any time the ignition is on.
NOTE: Always remember to return the vehicle to the valet OFF position. This
will ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE VALET/OVERRIDE SWITCH:
Your Security system can be disarmed without the use of the OEM transmitter.
This is necessary, since you will need the ability to operate your vehicle if the
transmitter is lost or its battery fails. To Bypass the system:
1. Open the vehicle door. The system will sound.
2. Turn the ignition key to the ON position.
3. Within 10 seconds, press and release the valet pushbutton switch.
The system will stop sounding and enter the (by-passed) mode. You can now
start and operate the vehicle normally.
Typically this override mode is used only if the Factory (OEM) transmitter has
become inoperative.