Filter
Top Products
Be sure motor is kept dry and covered. In mild climate area, when freezing may
occur, run pump and filter equipment continuously to prevent freezing.
MOTOR
Your pump is equipped with a permanently lubricated, maintenance-free, heavy-
duty industrial quality motor especially designed to withstand the heavy-duty
requirements of swimming pool application. Wiring connection must agree with
incoming line voltage. Improper wiring can cause serious injuries and damage to
the motor, voiding warranty.
NOTE: Your motor is designed to withstand the effects of normal rainfall. To
increase the life of your motor, observe the following:
1.) Do not flood motor or submerge in water. To do so voids warranty.
2.) Provide ample cross ventilation, minimum of 6” at all points.
3.) Keep motor and surrounding area clean.
4.) Avoid sweeping or stirring dust near motor while it is running.
5.) Avoid storing or spilling dry chemicals, powders, etc., near motor.
6.) Provide protection against the elements.
7.) Locate motor on a slight elevation so water will drain away from motor.
8.) Avoid spilling or dripping liquid chemical on or near motor.
9.) Avoid splashing water or hosing deck near motor. Water damage voids
warranty.
For replacements, contact your local supplier or authorized service center.
WARNING - All electrical wiring of the motor installation must be done by a
qualified electrician in accordance with applicable electrical codes. Before
working on any motor, be certain that the source of electrical power is off
at the main junction box.
BONDING WIRE - Upon installation of the pump, the motor must be bonded
with (no smaller than) a No. 8 AWG solid copper conductor per National
Electrical Code. The connection should be from the accessible wire
connector on the motor to all metal parts of the swimming pool, spa or hot
tub structure and to all electrical equipment, metal conduit, and metal
piping within 6 feet (1.5 m) of the inside walls of a swimming pool, spa or
hot tub, when the motor is installed within 5 feet of the inside walls of the
swimming pool, spa, or hot tub.
NOTE: For electrical connections, see wiring diagram on motor rating
plate.
3