Filter
Top Products
1
3
4
5
2
Setup Instructions
No Tools Required for Setup
• Unpack the pieces of the unit: LitterMaid
®
litter box, AC adapter (packed
in paper pulp), disposable waste receptacles, LitterMaid
®
scoop and rake
cleaner, use and care book and cleaning brush (packed with disposable waste
receptacles), plus any optional items including the carbon filters, paw-cleaning
ramp and litter box carpet.
• Cut and remove the restraints on each end of the rake. Peel off the protective
tape on the waste receptacle compartment cover and the battery compartment.
Remove the styrofoam on top of the rake.
Note: Battery compartment takes 8 "AA" cell batteries. (Batteries not included).
Important: Do not mix old and new batteries. Do not mix alkaline and
carbon-zinc (standard) batteries. Do not use rechargeable type (Ni-Cad, Ni-
MH or Li-lon) batteries.
• Place a disposable waste receptacle under the waste receptacle compartment
cover. Make sure that the front of the waste receptacle is under the five tabs
(Fig.-1). There should be no gap between unit and the waste receptacle. Attach
waste receptacle lid by inserting pushtabs into the round holes. To secure,
press on positions indicated (Fig. 2).
Installing carbon filter
• Peel off paper strip on the carbon filter to expose the adhesive. Place filter
adhesive-side down in diamond-shaped insert in center of waste receptacle lid
(Fig. 3). Close waste receptacle compartment cover.
• Use only hard clumping litter. Do not use non-clumping litter, crystal or pearl-
like litters. Fill LitterMaid
®
litter box to just below the "Max Line". Do not overfill
unit or it will not operate properly. Use the fill line on the LitterMaid® scoop and
rake cleaner to check that litter is at the correct level incenter of unit (Fig. 4).
4
Fig. 1
MA
X
MI
N
Fig. 2 Fig. 3
† 1. AC adapter (Part# LM680-05))
† 2. LitterMaid
®
scoop and rake cleaner (Part# LM680-06)
† 3. Paw cleaning ramp (Part# LM680-07)
† 4. Carbon Filters (8 included) (Part# LMF200)) (12 pk.)
† 5. Disposable waste receptacle (8 included)
(12 pk.) (Part# LMR200)
(18 pk.) (Part# LMR300)
Note: † Indicates consumer replaceable/removable parts
3
HOW THE LITTERMAID
®
SELF-CLEANING LITTER BOX
WORKS
• Cat enters the unit; once he/she leaves, the sensors are triggered, setting the
timer for the cleaning cycle. (Sensors need to be blocked for at least
5 seconds.)
Important: Unit will not start a cleaning cycle while cat is in the box.
• After 10 minutes, the cleaning cycle starts and the rake scoops out waste
clumps.
• If the cat re-enters and leaves the litter box before the initial 10 minutes have
elapsed, the rake will stop, the timer will automatically reset and delay the
beginning of the cleaning cycle for an additional 10 minutes.
Note: Rake will stop and reverse if the safety bar touches any object that has
gotten behind the rake while it is returning to its home position.
• Rake opens waste receptacle compartment cover and deposits clumps into the
waste receptacle.
• Sealed disposable waste receptacle allows for safe and easy disposal of waste
when full.
Accessories
Fig. 4
▼
Max Line
▼