Filter
Top Products
5
6
TEST INSTALLED FAUCET
INSTALL SPRAY HOLDER
7
Remove AERATOR. With handles in OFF
position, turn on water supplies and check
all connections for leaks.
Operate both HANDLES to flush water lines
thoroughly. Rotate SPOUT in both directions.
Replace AERATOR.
Place SPRAY HOLDER (1) into separate hole of SINK (2)
and assemble NUT (3) onto shank from underside of SINK (2).
Feed SPRAY HOSE (1) through SPRAY HOLDER (2) and
attach COUPLING NUT (3) of HOSE (1) to HOSE ADAPTOR (4)
on valve body. Tighten COUPLING NUT (3) firmly.
Unscrew SPRAY CAP (5) from HOSE ADAPTOR (4).
FITTING WITH SPRAY
Hand tighten NUT (3).
Direct SPRAY HEAD into sink and activate
SPRAY. Check HOSE connections for leaks.
Aerator may accumulate dirt causing distorted and
reduced water flow. Remove aerator and rinse clean.
If faucet drips proceed as follows:
3
4
5
1
2
8
SERVICE
9
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP (1) and remove
HANDLE SCREW (2).
Pull off HANDLE (3), and unscrew
ESCUTCHEON (4).
Pull off STEM ADAPTER (7).
Remove SPRING CLIP (6).
Lift STOP WASHER (5), turn 90
degrees and replace.
Replace SPRING CLIP (6) and STEM
ADAPTER (7).
Reinstall ESCUTCHEON (4) and
HANDLE ASSEMBLY (1,2 & 3).
If spout drips, operate handles several times
from OFF to ON position. Do not force - handles
turn only 90 .
90
5
6
2
4
3
7
1
M968412A
1
2
3
AERAT
O
NOTE: FAUCET can be installed with or without Hand Spray.